Skip to content

MRC-2020/2020R Setting Manual

There is no need to set the settings for normal use.
If the settings are wrong, return to the factory shipping by "Initialization".

Farmware latest version: 20200506_v0.1

* To enter the setting menu, you need to stop recording.
* The setting menu can be scrolled with up and down slides.
* The contents differ slightly depending on the firmware version.

Recording resolution: Specification of resolution

Loop recording: The recorded file is divided by the specified length (this is the general specification of the drive recorder, so that only the file at the time of the accident can be overwritten).

recording: Whether there is a recording

Auto recording: Automatically starts recording when the state does not operate when you turn it on for 30 seconds.

Emergency overwriting: If you turn it on, the emergency lock file is also overwritten from the old one when the microSD card is full.

Operating noise: Whether there is an operation sound

Rear camera mirror image: Mirror statue/positive image display switching

Date and time setting: You can set the date and time. When connected to GPS, it is automatically updated to accurate time, so setting is not required.

Date and time display: The date and time display on the screen (the date and time information is always recorded in the recorded file)

language: Operating language switching

Frequency setting: This is to suppress the flickering of the screen when looking at the screen under the fluorescent light. Set it to 50Hz in eastern Japan and 60Hz in western Japan. (There is no need to do it. It is different from the FPS frequency of the recorded file.)

screen saver: The screen is automatically turned off at the specified time. The recording is continuing because the screen is just off. Reverse the button under the main unit to re -tact.

G sensor sensitivity: The sensitivity setting of the impact detection sensor in the event of an accident.

Parking monitoring: The sensitivity setting of the impact detection sensor during parking monitoring.

Volume: Set the volume

GPS information: You can check the reception status of GPS. This is a channel that the green part is receiving. If there is no green bar at all, GPS may not be received.

Time zone settings: Please set to GMT+09:00 (in Japan)

Speed ​​unit: Please set to km/h

Speed ​​reminder: The warning will be displayed when the set speed exceeds the set.

GPS display: Whether there is a direction on the left of the screen/speed display

Up and lower reversal display: When turned on, the display of the rear camera and the top and bottom of the recording (top and bottom) in reverse. Use it when the rear camera is installed in the heavens and land.

12 tension/24 tension system: Clock display format

Automatic brightness adjustment: Switch the automatic/manual of the screen brightness adjustment. Automatic brightness adjustment is performed with the brightness of the front camera, so if there is an obstacle in front of the front camera, it may not work properly.

Guideline: Specify the presence or absence of the parking guideline line. This setting is invalid if you do not wire the parking guidelines

Initialization: Return the set value in this setting to the value at the time of shipment

format: Format the microSD card. Please make a format once every two weeks to ensure that the recording will be performed.Reference article

version: The version of the mirror cam finally is displayed.